Vintage Italian Wah Fastener Plate

Description

Vintage Italian Wah Fastener Plates – Early 60’s and 70’s made in Italy Wah Plates

If you are unsure about fitment or your particular model, please check out the Fitment Notes section for the specifics. These are very close to our popular Crybaby plate, so make sure you measure.

NEED A DIFFERENT WAH OR PEDAL PLATE?

What’s Included:

• Translucent & Durable 3/16″ Cast Acrylic Plate
• Industrial Grade Velcro strips – See How To Install Velcro Here!
• 4 stainless steel #6X32 by 3/8″ screws – You may need to re-use your existing screws, depending on enclosure screw mounting hole setup

Vintage Italian Wah Fastener Fitment Notes

• To verify proper fitment, measure the center points of the top and bottom holes along the same side of the wah. If you are close to 8 &1/16″ this is your jam baby!
• In RARE instances, our included stainless steel screws won’t fit your enclosure. We apologize in advance, but you’ll need to trek down to your local hardware outfit to locate some…or, try to use the screws that came with your pedal.